Performing SCSI Hot-Plugging Operations
This section provides various procedures and examples for performing SCSI hot-plugging
operations as listed in the following task map.
Table 2-1 SCSI Hot-Plugging With the cfgadm Command Task Map
|
|
|
Display information about SCSI devices.
|
Display information about SCSI controllers and devices.
|
|
Configure or unconfigure a SCSI controller.
|
Perform configuration or unconfiguration operations on a SCSI
controller.
|
|
Connect or disconnect a SCSI controller.
|
Perform connect or disconnect operations on a SCSI
controller.
|
|
Configure or unconfigure a SCSI device.
|
Perform configuration or unconfiguration operations on a specific
SCSI device.
|
|
Add a SCSI device to a SCSI bus.
|
Add a specific SCSI device to a SCSI bus.
|
|
Replace an identical device on a SCSI controller.
|
Replace a device on the SCSI bus with another device of the same
type.
|
|
Remove a SCSI device.
|
Remove a SCSI device from the system.
|
|
Troubleshoot SCSI configuration problems.
|
Resolve a failed SCSI unconfigure operation.
|
|
|
Note -
The SCSI framework generally supports hot-plugging of SCSI devices. However,
always consult your hardware documentation to confirm whether hot-plugging is
supported for your specific SCSI devices.