About Oracle VM Software Installation
Preparing for Oracle VM Server Installation
Install Oracle VM Server (Oracle System Assistant)
Installing Oracle VM Server (Manually)
Install Oracle VM Server (Local or Remote Media)
Installing Oracle VM Server (PXE Server)
PXE Server Installation Requirements
From the Oracle ILOM web interface, click Host Management > Power Control, and then from the Action list, select Reset.
From the Oracle local server, press the Power button (approximately one second) on the front panel of the server to power off the server, and then press the Power button again to power on the server.
From the Oracle ILOM CLI on the server SP, type: reset /System. The BIOS screen appears.
The Please select boot device menu appears listing the available boot devices.
The network bootloader loads, and a boot prompt appears. The prompt allows you to choose the PXE server to install from.
After a few seconds the installation kernel begins to load.
Oracle VM server is installed.
Next Steps
Install Oracle VM Manager, if needed. Refer to: