JavaScript is required to for searching.
Skip Navigation Links
Exit Print View
Sun Ethernet Fabric Operating System

QoS Administration Guide
Oracle Technology Network
Library
PDF
Print View
Feedback
search filter icon
search icon

Document Information

Using This Documentation

Product Notes

Related Documentation

Acronyms and Abbreviations

CLI Command Modes

Feedback

Support and Accessibility

Configuration Overview

QoS Management Architecture

Configuring QoS

Introduction

Classifying and Conditioning Ingress Traffic

Introduction

Define an ACL and Access Group

Define TCP and UDP Traffic

Define VLAN Tagged Packets

Define Incoming Packet Priorities

Define the Traffic Classes With the class-map Command

Set the Rate and Burst Tolerance of a Traffic Stream

Set up the Ingress Policy

Classifying and Scheduling Egress Class Traffic

Define the Egress Scheduler Behavior

Define a General Shaper

Insatiate Egress Queues

Mapping Ingress Traffic to Egress Class

Map Ingress Traffic to Egress Class

CLI Command Modes

The following table lists the configuration modes used in this document with their access and exit methods.

Command Mode
Access Method
Prompt
Exit Method
User EXEC
Access SEFOS from Oracle ILOM with read-only rights (privilege level 1).
SEFOS>
Use logout or exit to return to the Oracle ILOM prompt.
Privileged EXEC
Access SEFOS from Oracle ILOM with full administrative rights (privilege level 15).
SEFOS#
Use the logout or exit command to return to the Oracle ILOM prompt.
Global Configuration
From User EXEC mode, use the enable command.
SEFOS(config)#
Use the end command to return to Privileged EXEC mode.
Interface Configuration
From Global Configuration mode, use the interface interface-type interface-id command.
SEFOS(config-if)#
Use the exit command to return to Global Configuration mode, or use the end command to return to Privileged EXEC mode.
Copyright © 2010, 2012, Oracle and/or its affiliates. All rights reserved. Legal Notices
Previous Next