Perform this procedure from any cluster node.
Before You Begin
Ensure that you have the name of the resource that you are disabling and enabling.
# clresource disable resource # clresource enable resource
Specifies the name of the resource.
# clresource status
The output from this command indicates the state of the resource that has been disabled and re-enabled.
This example shows how to clear a Start_failed resource state that has occurred on the rscon resource by disabling and enabling the resource.
Verify that the resource is in the Start_failed resource state.
# clresource status === Cluster Resources === Resource Name Node Name Status Message -------------- ---------- ------- ------- rscon phys-schost-1 Faulted Faulted phys-schost-2 Offline Offline hastor phys-schost-1 Online Online phys-schost-2 Offline Offline
Disable and re-enable the resource.
# clresource disable rscon # clresource enable rscon
Verify that the resource is re-enabled and that the Start_failed resource status is cleared.
# clresource status === Cluster Resources === Resource Name Node Name Status Message -------------- ---------- ------- ------- rscon phys-schost-1 Online Online phys-schost-2 Offline Offline hastor phys-schost-1 Online Online phys-schost-2 Offline Offline
See Also
The clresource(1CL) man page.