1 Get Started with Installation

You can install and configure Oracle Enterprise Manager Ops Center with Oracle Solaris operating system.

This documentation describes the procedures required to install and configure Oracle Enterprise Manager Ops Center.

This chapter includes the following sections:

Planning the Installation

Before you start with the installation procedure, you must perform some of the tasks to prepare the system for installation.

The following are the typical sequences of tasks when installing Oracle Enterprise Manager Ops Center:

  1. Review the system requirements to determine what equipment you need.
  2. Prepare a set of systems for software installation, including installing operating systems and verifying that adequate system resources are available.
  3. Install and configure an Enterprise Controller. If you are using a High Availability configuration, install and configure at least two Enterprise Controller nodes.
  4. Install and configure at least one Proxy Controller. This can be the co-located Proxy Controller, which is installed with the Enterprise Controller.

The first two tasks are described in the Preparing Your Environment chapter. The third task is discussed in the Installing with Enterprise Controller High Availability and Installing with a Single Enterprise Controller chapters. The final task is described in the Installing Proxy Controllers chapter.

Figure 1-1 shows the steps involved in an Oracle Enterprise Manager Ops Center installation.

Figure 1-1 Site Preparation, Installation and Configuration

Description of Figure 1-1 follows
Description of "Figure 1-1 Site Preparation, Installation and Configuration"

Enterprise Controllers and Proxy Controllers can be installed on Oracle Solaris 10, Oracle Solaris 11, Oracle Linux, or Red Hat Enterprise Linux.

Review the supported OS versions and the security considerations before you begin with the installation.

Installing and Configuring Oracle Enterprise Manager Ops Center

Once you have fully prepared the systems, you install and configure Oracle Enterprise Manager Ops Center.

An Oracle Enterprise Manager Ops Center installation has three components:

  • An Enterprise Controller: The Enterprise Controller directs Oracle Enterprise Manager Ops Center actions and generates the user interface. If you plan to use high availability, you install multiple Enterprise Controllers, but only one is active at a time.

  • One or more Proxy Controllers: Proxy Controllers store Oracle Enterprise Manager Ops Center data and route jobs to managed systems.

  • Agent Controllers for managed systems: Agent Controllers communicate monitoring data, help run jobs, and enable software update support on managed systems. Agent Controllers can be installed when a system is discovered and managed.

You can install and configure Proxy Controllers in one of four ways:

  • Configure the co-located Proxy Controller that was automatically installed with the Enterprise Controller

  • Remotely deploy one or more Proxy Controllers as part of the Enterprise Controller configuration

  • Remotely deploy one or more Proxy Controllers using the Deploy Proxy Controller Wizard

  • Manually install and configure one or more Proxy Controllers

Once the Enterprise Controller and Proxy Controllers are installed and configured, Oracle Enterprise Manager Ops Center is functional.

Related Resources for Oracle Solaris OS Installation

You can view the Oracle Enterprise Manager Ops Center documents for additional information.

For more information, see these Oracle resources: