The QoS management architectures in the SEFOS hardware are based on the IETF Differentiated Service Architecture. However, in this architecture, routing and forwarding are decoupled from the QoS configuration.
In the following illustration, the arrows indicate the order of the scripts to be entered.
The following illustration shows a Layer 2 network. There are four down-stream ports and one up-link port. The traffic should be separated into different queues on the up-link. IP traffic from port 0/2 is separated into two classes: one for UDP packets and one for TCP packets. At port 0/3, VLAN 1000 frames are grouped into one class. At port 0/4, the priority of VLAN frames is changed to 3. In this example, the egress queue is different than the default queue for priority 3.
The layer 2 network is configured by the following commands:
SEFOS# configure terminal SEFOS(config)# vlan 1000 SEFOS(config-vlan)# ports extreme-ethernet 0/1-5 SEFOS(config-vlan)# exit SEFOS(config)# no shutdown qos SEFOS(config)# qos enable SEFOS(config)# exit SEFOS# show qos global info QoS Global Information ---------------------- System Control : Start System Status : Enable Rate Unit : kbps Rate Granularity : 64 Trace Flag : 0