The program description deals with the following:
The data for configuration of scales, type EW300 can be updated, i.e. programmed, changed or cleared, with this program. Data which has already been stored can also be displayed for information.
The interface and link to a processing unit should be defined and the device-specific operating mode of the scales set.
The following description deals with all available options for update of this basic data.
As with nearly all other programs the following also applies here:
Entry range permitted: numeric
Default = 1
Entry range permitted: alphanumeric max. 20 chars.
Enter the type or model designation of connected scales.
Field with firmly defined selection options
Select one of the debug levels offered by clicking onto this field and confirming the selection with a second click.
The system offers the following debug levels:
Note:
Only select a value higher than "0" for
the debug level if a communications protocol is required for error analysis.
The details appear in file "errlog" in directory work of the appropriate system unit.
Field with firmly defined selection options
Select one of the baud rates offered by clicking onto this field and with a second click confirming the selection.
The system offers the following baud rates:
Please note that the baud rate permitted must match up to the setting of the scales type connected.
Default = 1000 milliseconds
Enter a value in milliseconds in this field to define the intervals at which the scales should answer after a status request. The error message Scales offline appears if the response is negative.