The program description deals with the following:
The data for a Symbol Terminal can be updated, i.e. programmed, changed or cleared, with this program. Data which has already been stored can also be displayed for information.
The interface and link to a processing unit should be defined and the device-specific operating mode of the device set.
The following description deals with all available options for update of this basic data.
As with nearly all other programs the following also applies here:
Entry range permitted: numeric 0 - 9
Default = 1 (yes)
Entry range permitted: numeric 1 - 9999
The system offers the following debug levels:
Note:
Only select a value higher than "0" for
the debug level if a protocol for communication of the device is required for
error analysis. The details are shown in file "errlog" in directory work of the appropriate system unit.
Entry range permitted: numeric 1 - 9
Enter the number of the operator display which is to be used for this terminal.
Default = 1 (yes)
Default = 10 (no)
Entry range permitted: numeric 0 - 9
Enter the number of the printer which is to be used for this terminal.
Entry range permitted: numeric 0 - 9999
Default = 10 (milliseconds)
Entry range permitted: numeric 20 - 128
Enter the number of characters to be printed in one line.
Entry range permitted: numeric 20 - 128
Enter the number of characters per line the connected printer can produce.
Entry range permitted: numeric 0 - 99
Enter the number of lines the receipt is to advance before it is cut off.