Go to primary content
Diameter Signaling Router SS7/Sigtran
Release 8.2
E89009
Go To Table Of Contents
Contents

Previous
Previous
Next
Next

Remote Signaling Points Maintenance elements

Table 3-5 describes the information on the SS7/Sigtran > Maintenance > Remote Signaling Points page.

Table 4-3 Remote Signaling Points Maintenance Elements

Element Description
Remote Point Code The point code for this RSP.
SS7 Domain The SS7 domain of the RSP.
RSP Status RSP Status is an aggregation of the statuses for Route 1 and Route 2. The intent is to display the MP Server's ability to signal to the RSP. Possible values are:
  • Available-at least one route is available.
  • Unavailable-both routes are down/unavailable.
  • Congested-a report has been received from the network that the RSP is congested, but not unavailable.
  • Forced Standby-the MP Server's HA state has been manually set to Forced Standby via the HA Status page. All signaling is inhibited for MP Servers that are in the Forced Standby state.
  • Non-Preferred-the lower cost route is down/unavailable, causing signaling to use the non-preferred route.
  • Application Disabled-the application has been manually disabled via the Server Status page.
Route X Status, where Route X is Route 1 or Route 2 align="left">Route Status is an aggregation of Link Set Status and Network Status. If either the Link Set Status is Down or the Network Status is Unavailable, the route is Unavailable.
Link Set Status Corresponds to the status of the Link Set that the Route is configured to use, as shown on the Link Set Maintenance page. Possible values are Up or Down. If Down, more information can be found on the Link Set Maintenance page. For information on Link Set Maintenance, see Link Set Maintenance.
Network Status Indicates the Route status reported from the network. Possible values are Available or Unavailable. Unavailable means that a DUNA/TFP was received from a signaling gateway indicating that the RSP is not accessible from that signaling gateway. A restricted route is displayed as available.
Time of Last Status Change Indicates the last time when any status change occurred on this row, including changes for the RSP status and the link set and network status for Route 1 and Route 2.
MP Server Hostname The hostname of the MP Server reporting the status.
Route X Details, where Route X is Route 1 or Route 2. Route Details provides detailed information about Route 1 and Route 2.
Route Cost The cost associated with the Route.
Link Set Name The Link Set associated with the Route.
Adjacent Point Code The Adjacent Point Code associated with the Route.
Pause updates Unchecked by default to refresh every 15 seconds. Checked stops the updates.