4.375 inh-trm

Use this command to set the primary state of a serial port to OOS-MT-DSBLD . It sets the secondary state to MANUAL . The serial port is not available to perform service functions. There is no outgoing traffic from the serial port, and all incoming traffic is ignored.

Parameters

trm (mandatory)

The ID of serial port to be inhibited

Range:

1 - 40

force (optional)

This parameter forces the removal of a specified terminal, even if it is last in-service SEAS terminal available.

Range:

yes

no

Default:

no

Example

inh-trm:trm=5

inh-trm:trm=1:force=yes

Dependencies

No other action command can be in progress when this command is entered.

The IP User Interface feature must be enabled before terminal ports 17 through 40 can be specified for the trm parameter.

The terminal specified by the trm parameter must be equipped.

This command cannot be used to inhibit the terminal from which the command is entered.

The force=yes parameter must be specified to inhibit the last in-service SEAS terminal.

Notes

When inhibiting an already inhibited terminal, a warning message is echoed to the scroll area, but no action is taken.

Output

inh-trm:trm=5

    rlghncxa03w 04-01-07 11:11:28 EST  EAGLE 31.3.0
    Inhibit message sent to terminal 
;

inh-trm:trm=17:force=yes

    tekelecstp 07-01-23 18:46:01 EST  EAGLE 37.5.0
    Inhibit message sent to terminal 
;