4.475 rtrv-e1

Use this command to retrieve information for a specified E1 interface or for all E1 interfaces that have been defined by the ent-e1 command for an E5-E1T1-B card used as an E1 or SE-HSL card. 

Parameters

e1port (optional)
E1 port number

The value must be an E1 port that has already been configured with an E1 interface on the specified E1 card (loc parameter).

Range:
1 - 8
Default:
If not specified, all E1 ports are listed.
loc (optional)
The card location as stenciled on the shelf of the system.
Range:
1101 - 1108, 1111 - 1112, 1201 - 1208, 1211 - 1218, 1301 - 1308, 1311 - 1318, 2101 - 2108, 2111 - 2118, 2201 - 2208, 2211 - 2218, 2301 - 2308, 2311 - 2318, 3101 - 3108, 3111 - 3118, 3201 - 3208, 3211 - 3218, 3301 - 3308, 3311 - 3318, 4101 - 4108, 4111 - 4118, 4201 - 4208, 4211 - 4218, 4301 - 4308, 4311 - 4318, 5101 - 5108, 5111 - 5118, 5201 - 5208, 5211 - 5218, 5301 - 5308, 5311 - 5318, 6101 - 6108, 6111 - 6118
Default:
If not specified, all E1 card locations are listed.

Example

rtrv-e1

rtrv-e1:loc=1307:e1port=2

rtrv-e1:loc=1311:e1port=1

Dependencies

The loc and e1port parameters must be specified together in the command.

The E1 interface of the E1 card specified by the loc parameter must already be defined (see the ent-e1 command) before this command can be entered.

The card specified by the loc parameter must be a LIME1 card type.

The Card (IMT) table must be accessible.

The E1/T1 table must be accessible.

An E1 interface must already be defined on the port specified by the e1port parameter before this command can be entered.

The following card locations (loc parameter) are not valid for this command: 1113 through 1118 and all xy09 and xy10 locations (where x is the frame and y is the shelf).

Notes

None.

Output

Legend

  • LOC—E1 card location
  • E1PORT—E1 port number on an E1 card
  • CRC4—CRC4 indicator
  • ENCODE—Indicator for use of HDB3 or AMI encoding/decoding
  • SI—Value of two Spare International bits of NFAS data
  • SN—Value of five Spare National bits of NFAS data
  • MINSURATE—Minimum number of signaling units present on a link uniformly distributed. A value appears in this field only when the LINKCLASS field value is UNCHAN.
  • TSx—Timeslot

Related Topics