Install the Floor in the Bottom Expansion Module

Install the floor on the module that will reside at the bottom of the library.

Only perform this procedure for the bottom module. It is easiest to install the floor before mounting the bottom module into the rack.

1. Turn the module over.
2. Orient the floor so the finger holds are facing the inside of the cartridge magazine slot (see Figure 2-13).
3. Insert the rear edge of the floor into the grooves at the bottom of the module.
4. Push the floor in and engage the rear floor tab with the module slot (see Figure 2-16).
5. Push the floor in and seat the floor clip in each magazine bay (see Figure 2-17).
6. Turn the module over and verify the floor clips properly engage the chassis.

   Figure 2-16 Library Floor

   

   Illustration Legend:

   • 1 - Floor Slot
   • 2 - Floor Tab

   Figure 2-17 Floor Secured

   

   Illustration Legend:

   • 1 - Floor Clip
   • 2 - Floor