Power On the Server
- To power on the server, do one of the following:
- To initiate the power-on sequence from the service processor prompt, issue the poweron
- You will see an -> Alert message on the system console. This message
indicates that the system is reset. You will also see a message indicating
that the VCORE has been margined up to the value specified in the
default.scr file that was previously configured.
-> start /SYS
- To initiate the power-on sequence manually, use a pen or pencil to press
the Power button on the front panel. See Front Panel Diagram for Power button location.
Note - If you are powering on the server following an emergency shutdown triggered by
the top cover interlock switch, you must use the poweron command.