Documentation, Support, and Training
Understanding Switch Specifications
Network Management Connector and Pins
USB Management Connector and Pins
Understanding InfiniBand Cabling
Floor and Underfloor Delivery of InfiniBand Cables
Overhead Delivery of InfiniBand Cables
Understanding the Installation
Install the Switch in the Rack
Accessing the Management Controller
Access the Management Controller From the Network Management Port
Access the Management Controller From the USB Management Port
Verifying the InfiniBand Fabric
Discover the InfiniBand Fabric Topology
Perform Diagnostics on the InfiniBand Fabric
Identify the prerequisite and subsequent installation tasks that you must perform in conjunction with this procedure.
On the management controller, determine the state of the links:
# listlinkup
If the link for a connector is reported as Not present, there is no cable attached or the link at either end of the cable is down.
If a port is down, use the enableswitchport command to bring the port up. Alternatively, use the i4reset command to reset the entire switch chip. See Enable a Switch Chip Port and Reset the Switch Chip.
Verify the InfiniBand fabric.
Switch Reference, listlinkup command
Switch Reference, enableswitchport command
Switch Reference, i4reset command