See the installation guide for your server for instructions.
% ssh firstname.lastname@example.org ... Are you sure you want to continue connecting (yes/no) ? yes ... Password: password (nothing displayed) Waiting for daemons to initialize... Daemons ready Integrated Lights Out Manager Version 3.x.x.x Copyright 2010 Oracle and/or its affiliates. All rights reserved. Use is subject to license terms. ->
-> stop /SYS
-> set /SYS keyswitch_state=normal
The load command updates the SP flash image and the host firmware. The load command requires the following information:
IP address of a TFTP server on the network that can access the flash image.
Full path name to the flash image that the IP address can access.
The command usage is as follows:
load [-script] -source tftp://xxx.xxx.xx.xxx/pathname
-script - Does not prompt for confirmation and acts as if yes was specified.
-source - Specifies the IP address and full path name (URL) to the flash image.
-> load -source tftp://126.96.36.199/pathname NOTE: A firmware upgrade will cause the server and ILOM to be reset. It is recommended that a clean shutdown of the server be done prior to the upgrade procedure. An upgrade takes about 6 minutes to complete. ILOM will enter a special mode to load new firmware. No other tasks can be performed in ILOM until the firmware upgrade is complete and ILOM is reset. Are you sure you want to load the specified file (y/n)?y Do you want to preserve the configuration (y/n)? y ................................................................. Firmware update is complete. ILOM will now be restarted with the new firmware. Update Complete. Reset device to use new image. ->
After the flash image has been updated, the server automatically resets, runs diagnostics, and returns to the login prompt on the serial console.
U-Boot 1.x.x Custom AST2100 U-Boot 3.0 (Aug 21 2010 - 10:46:54) r58174 *** Net: faradaynic#0, faradaynic#1 Enter Diagnostics Mode ['q'uick/'n'ormal(default)/e'x'tended(manufacturing mode)] ..... 0 Diagnostics Mode - NORMAL <DIAGS> Memory Data Bus Test ... PASSED <DIAGS> Memory Address Bus Test ... PASSED I2C Probe Test - SP Bus Device Address Result === ============================ ======= ====== 6 SP FRUID (U1101) 0xA0 PASSED 6 DS1338(RTC) (U1102) 0xD0 PASSED <DIAGS> PHY #0 R/W Test ... PASSED <DIAGS> PHY #0 Link Status ... PASSED <DIAGS> ETHERNET PHY #0, Internal Loopback Test ... PASSED ## Booting image at 110a2000 ... *** Mounting local filesystems... Mounted all disk partitions. Configuring network interfaces...FTGMAC100: eth0:ftgmac100_open Starting system log daemon: syslogd and klogd. Starting capidirect daemon: capidirectd . Done Starting Event Manager: eventmgr . Done Starting ipmi log manager daemon: logmgr . Done Starting IPMI Stack: . Done Starting sshd. Starting SP fishwrap cache daemon: fishwrapd . Done Starting Host deamon: hostd . Done Starting Network Controller Sideband Interface Daemon: ncsid . Done Starting Platform Obfuscation Daemon: pod . Done Starting lu main daemon: lumain . Done Starting Detection/Diagnosis After System Boot: dasboot Done Starting Servicetags discoverer: stdiscoverer. Starting Servicetags listener: stlistener. Starting Dynamic FRUID Daemon: dynafrud Done hostname login: