Remove the Fan Assembly Door From a Server With 2.5-Inch Drives
Before you service the server's storage drive backplane, you should first remove the
server's front fan assembly door.
Note - This procedure applies only to servers with 2.5-inch storage drives.
- Ensure that the AC power cords are disconnected from the server power supplies.
- Using a No. 1 Phillips screwdriver, remove the two screws (one on each
side of the chassis) that secure the fan assembly door .
Figure 40 Removing the Fan Assembly Door
- Slide the fan assembly door toward the rear of the server, and lift
and remove the door from the chassis .