Rear Panel Connector Locations
The following illustration shows and describes the locations of the back panel
connectors. Use this information to set up the storage server, so that you can access
diagnostic tools and manage the storage server during service.
|
|
|
1
|
Power supply 0 input power
Power supply 1 input power
|
The storage server has two power supply connectors, one for each power
supply.
Do not attach power cables to the power supplies until you have
finished connecting the data cables to the storage server. The storage server
goes into standby power mode, and the Oracle ILOM service processor
initializes when the AC power cables are connected to the power source.
System messages might be lost after 60 seconds if the storage server is not
connected to a terminal, PC, or workstation.
Note -
Oracle ILOM will signal a fault on any installed power supply that
is not connected to an AC power source, since it might indicate a loss
of redundancy.
|
2
|
Network management port (NET MGT)
|
The service processor NET MGT port is the optional connection to the
Oracle ILOM service processor. The NET MGT port is configured by default
to use Dynamic Host Configuration Protocol (DHCP). The service processor
NET MGT port uses an RJ-45 cable for a 10/100/1000BASE-T
connection.
|
3
|
Ethernet ports (NET 3, NET 2, NET 1, NET 0)
|
The four 10-Gigabit Ethernet ports enable you to connect the system to
the network.
|
4
|
Serial management port (SER MGT)
|
The service processor SER MGT port uses an RJ-45 cable and is the
default connection to the Oracle ILOM service processor. This port
supports local connections to the storage server and only recognizes Oracle
ILOM command-line interface (CLI) commands. Typically you connect a
terminal or terminal emulator to this port.
Note -
This port does not support network connections.
|
5, 6
|
USB ports (USB 0, USB 1)
|
The two USB ports support hot-plugging. You can connect and disconnect
USB cables and peripheral devices while the storage server is running
without affecting system operations.
|
7
|
Video port (VGA)
|
Use a 15-pin video cable to connect a VGA video device to the storage
server. Optionally, you can connect to the VGA port when installing the
operating system.
|
|