Communicating With the ILOM and the System Console
About ILOM SP IP Addresses and the ILOM Interfaces
How to Get the SP IP Address by Using the BIOS Setup Utility
How to Connect to the ILOM CLI Using the Serial Management Port
How to Connect to the ILOM CLI Using SSH
How to Connect to the ILOM Web Interface
Connecting to the System Console
How to Connect to the Server Locally (Physical Console)
How to Connect to the Host's Serial Console Using the ILOM Command-Line Interface
How to Connect Remotely Using the ILOM Web Interface
Before You Begin
Complete the hardware setup as described in the hardware setup documentation.
Apply standby power for your server. See How to Apply Standby Power for Initial Service Processor Configuration for the location of the power cord connectors.
This is described in How to Connect to the ILOM CLI Using the Serial Management Port.
The SP displays its default command prompt:
->
show /SP/network Targets: test Properties: commitpending = (Cannot show property) dhcp_server_ip = 10.80.193.10 ipaddress = 10.80.193.163 ipdiscovery = DHCP ipgateway = 10.80.195.254 ipnetmask = 255.255.252.0 macaddress = 00:21:28:44:F4:EE pendingipaddress = 10.80.193.163 pendingipdiscovery = DHCP pendingipgateway = 10.80.195.254 pendingipnetmask = 255.255.252.0 state = enabled switchconf = (none) Commands: cd set show
The ILOM displays network information, including the IP address.