Exit Print View | |
Sun Integrated Lights Out Manager (ILOM) 3.0 Supplement for the Sun Netra T6340 Server Module |
![]() |
Documentation, Support, and Training
Understanding ILOM for the Sun Netra T6340 Server Module
Chassis Monitoring Module Features
Resetting the Password to the Factory Default
Viewing and Configuring Host Control Information
Managing Host Diagnostics and POST
Specify the Level of Diagnostics (CLI)
Change the Diagnostics Mode (CLI)
Choose the Amount of Verbosity in Diagnostic Output (CLI)
Manage Diagnostic Settings (CLI)
Managing System User Interactions
Managing the Service Processor
Changing Service Processor Settings to Factory Defaults
Change Console Escape Characters (CLI)
Changing Configuration Policy Settings
Managing Power Usage and Monitoring Power Consumption
Monitoring Active System Faults
Managing Virtual Keyswitch Settings
Configuring the Host for Using Remote Console With OpenBoot
Configuring the Host for Using Remote Console With Solaris OS
Sensors on the Sun Netra T6340 Server Module
Indicators on the Sun Netra T6340 Server Module
Limits to Backward Compatibility
Create an ALOM CMT Compatibility Shell
Switch Between the ALOM CMT Shell and the Host Console
Return to the ILOM From the ILOM CMT Shell
Comparing ILOM and ALOM CMT Commands
Event Messages Available Through the ALOM Compatibility Shell
Service Processor Usage Event Messages
Environmental Monitoring Event Messages
Use the /HOST diag trigger property to control the conditions under which POST runs if diagnostics are enabled.
At the -> prompt, type:
-> set /HOST diag trigger=value
where value is one (or a combination, supplied within quote marks and separated by a space) of the following:
user-reset - Run diagnostics when the system is reset.
error-reset - Run diagnostics when the system takes a fatal error that requires the system to reset itself to recover.
power-on-reset - Run diagnostics when the system is powered on.
all-resets - Run diagnostics at any server reset.
none - Skip diagnostics.
The default value is the combination of power-on-reset error-reset.
For example:
-> set /HOST/diag trigger=”user-reset power-on-reset” Set ‘trigger’ to ‘user-reset power-on-reset’ -> show /HOST/diag trigger Properties: trigger = user-reset power-on-reset Commands: set show ->