Skip Navigation Links | |
Exit Print View | |
Sun Ethernet Fabric Operating System PIMv6 Administration Guide |
Configuring the Topology Example
Enable IPv6 Support and Assign IPv6 Addresses
Configure the SPT Switching Period
Configure the Rendezvous Point Threshold
Configure the RP Switch Period
Configure the regstop Rate Limit
Configuring PIMv6 on an Interface
Associate the PIMv6 Component to an Interface
Configure the Query-Interval Value
Configure the DR Priority Value
Configure the Override Interval
Configure the Message Interval
Configuring the PIMv6 Component
Set the Mode for the PIMv6 Component
Configure the RP-Candidate Hold Time
Configure the RP-Candidate Address
Configuring the PIMv6 group threshold sets the maximum limit for the rate of the flow of data in the group. Configuring the source threshold sets the maximum limit for the rate of the flow of data from the source to the receiver. When the rate of the flow of data exceeds the SPT group or source threshold, switching to the SPT is initiated. You must configure the threshold value to switch to SPT.
SEFOS# configure terminal SEFOS(config)# set ipv6 pim enable SEFOS(config)# end
SEFOS# configure terminal SEFOS(config)# set ip pim threshold spt-grp 10
SEFOS(config)# set ip pim threshold spt-src 15 SEFOS(config)# end
SEFOS# show ipv6 pim thresholds PIM SPT Threshold Information ----------------------------- Group Threshold : 10 Source Threshold : 15 Switching Period : 0 PIM SPT-RP Threshold Information -------------------------------- Register Threshold : 0 RP Switching Period : 0 Register Stop rate limit : 5