Skip Navigation Links | |
Exit Print View | |
Sun Ethernet Fabric Operating System PIMv6 Administration Guide |
Configuring the Topology Example
Enable IPv6 Support and Assign IPv6 Addresses
Configure the Group and Source Thresholds
Configure the SPT Switching Period
Configure the Rendezvous Point Threshold
Configure the RP Switch Period
Configure the regstop Rate Limit
Configuring PIMv6 on an Interface
Configure the Query-Interval Value
Configure the DR Priority Value
Configure the Override Interval
Configure the Message Interval
Configuring the PIMv6 Component
Set the Mode for the PIMv6 Component
Configure the RP-Candidate Hold Time
Configure the RP-Candidate Address
The ipv6 pim componentId command adds an interface to the PIMv6 component and enables PIMv6 on the interface. You must associate a PIMv6 component with the interface to turn the interface into a supported PIMv6 module. In addition, you must create a component before you associate that component with an interface, except for the default component 1. See Configuring the PIMv6 Component for instructions on how to create a component.
SEFOS# configure terminal SEFOS(config)# set ipv6 pim enable
SEFOS(config)# interface vlan 1 SEFOS(config-if)# ipv6 pim componentId 2 SEFOS(config-if)# end
SEFOS# show ipv6 pim interface detail ... PIM Lan-Prune-Delay : Disabled PIM Component Id : 2 ...