Skip Navigation Links | |
Exit Print View | |
Sun Ethernet Fabric Operating System PIMv6 Administration Guide |
Configuring the Topology Example
Enable IPv6 Support and Assign IPv6 Addresses
Configure the Group and Source Thresholds
Configure the SPT Switching Period
Configure the Rendezvous Point Threshold
Configure the RP Switch Period
Configure the regstop Rate Limit
Configuring PIMv6 on an Interface
Associate the PIMv6 Component to an Interface
Configure the Query-Interval Value
Configure the DR Priority Value
Configure the Override Interval
Configuring the PIMv6 Component
Set the Mode for the PIMv6 Component
Configure the RP-Candidate Hold Time
Configure the RP-Candidate Address
When you configure the PIMv6 message interval, you set the frequency at which PIMv6 join or prune messages are transmitted on a PIMv6 interface. The join or prune message interval must be the same on all of the PIMv6 routers in the PIMv6 domain. If all of the routers do not use the same timer interval, then the performance of the PIMv6 sparse mode can be adversely affected.
SEFOS(config)# interface vlan 7 SEFOS(config-if)# ipv6 pim componentId 1 SEFOS(config-if)# end
SEFOS# configure terminal SEFOS(config)# interface vlan 7 SEFOS(config-if)# ipv6 pim message-interval 120 SEFOS(config-if)# end
SEFOS# show ipv6 pim interface detail vlan7 34 is up ... PIM Message Interval : 120 ...