About This Documentation (PDF and HTML)
Overview of the Sun Blade Storage Module M2
Installing the Storage Module Into the Chassis
Assigning and Managing Storage
Overview of the Sun Blade Storage Module M2 Product Notes
Supported Firmware, Hardware and Software
Solaris Operating System Issues
Performing Maintenance and Hot Plug Actions
Importing Existing Virtual Drives to a Replacement REM
Storage Module Sensors and Indicators
Displaying Sensor and Indicator Information Using the CMM ILOM Web Interface
Displaying Sensor and Indicator Information Using the CMM ILOM CLI
Introduction to the Sun Blade Storage Module M2
Maintaining the Sun Blade Storage Module M2
This section describes hard disk drive sensors.
Note - HDD applies to both mechanical and solid-state disk drives.
Syntax (enter target HDD):
-> /CH/BLx/HDDx
Output:
/CH/BL7/HDD6 Targets: SERVICE Properties: type = Hard Disk disk_type = SAS wwn = 0x5000c5000f7d7ce9, 0x5000c5000f7d7cea sas_speed = 6.0 Gbps Commands: cd show
|