About This Documentation (PDF and HTML)
Overview of the Sun Blade Storage Module M2
Installing the Storage Module Into the Chassis
Assigning and Managing Storage
Overview of the Sun Blade Storage Module M2 Product Notes
Supported Firmware, Hardware and Software
Solaris Operating System Issues
Performing Maintenance and Hot Plug Actions
Importing Existing Virtual Drives to a Replacement REM
Storage Module Sensors and Indicators
Viewing the CMM ILOM Event Log
Sun Blade Zone Manager Not Ready
Missing SAS-2 Components Error
Server Module Not SAS-2 Capable Error
Newly Inserted NEM is Not Discovered
Storage Module Becomes Inaccessible at Host and ILOM /CH/BLx/fault_state is "Faulted"
Storage Module Becomes Inaccessible at Host and ILOM /CH/BLx/STATE is "Degraded"
Storage Module Fault LED is On
SAS Path Disappears and ILOM /CH/NEMx/fault_state is "Faulted"
NEM STATE (/CH/NEMx/STATE) is Not "Running"
NEM /CH/NEMx/OK Indicator is in Standby Blink
Introduction to the Sun Blade Storage Module M2
Maintaining the Sun Blade Storage Module M2
This section describes general issues with the NEM. Since the NEM is an integral part of the SAS-2 fabric, problems with NEMs can cause storage devices or paths to storage devices to become inaccessible at the host.
Note - If your chassis has only one NEM, it must be installed in NEM 0. Operating a chassis without a NEM in NEM 0 is not supported.