Exit Print View

Sun Netra CP3270 ATCA Blade Server User’s Guide
Get PDF Book Print View
 
Servicing the Blade Server Previous Next

Document Information

Using This Documentation

UNIX Commands

Shell Prompts

Related Documentation

Documentation, Support, and Training

Documentation Feedback

Evaluating Product Compatibility

Evaluating the Blade Server

Qualifying Your System

Installing the Blade Server

Preparing to Install the Blade Server

Installing Components and Blade Server

Installing Optional Components

Software and Firmware Upgrades

Administering the System

Software and Firmware Upgrades

Performing a Server Recovery

Administering Parameters and Configurations

Configuring Ports and Pins

Administering the Network

Administering User Accounts and Security

Servicing the Blade Server

LEDs and Status Indicators

Reset the Blade Server

Replacing a Blade Server

Removing Optional Components

Return a Blade Server

Part Number, Serial Number, and MAC Address Label Locations

Programming the Blade Server

Sensors

I2C Device Mapping

AMC and ARTM Traffic Port

OEM and IPMI Commands

Glossary

Index

Reset the Blade Server

Caution

Caution - Do not operate the ATCA shelf without all fans, component heatsinks, air baffles, filler panels, and covers installed. Severe damage to components can occur if the ATCA shelf is operated without adequate cooling mechanisms.

  1. Use a spudger tool or other stylus to press and release the recessed Reset button on the front of the blade server.


    Figure showing Reset button on front of blade server.

  2. Confirm the progress of the reset by monitoring the BIOS POST messages.

Copyright © 2010 Oracle and/or its affiliates. All rights reserved. Legal Notices
Previous Next