If you installed or replaced a tape drive, go to "Closing the Upper Front Panel".
If you installed or replaced a bay disk drive, go to "Closing the Lower Front Panel".
If you installed or replaced an SBus card or a DSIMM, go to "Replacing Foam Piece 1 and the Left Panels".
Swing the upper front panel closed and press against the left side to snap the panel into place.
Swing the lower front panel closed and press against the left side to snap the panel into place (Figure 2-24).
Insert the right side of Foam Piece 1 into its proper location (Figure 2-25).
Fit Foam Piece 1 behind the system disk connectors. Be careful not to dislodge the connectors.
Rotate the left side of the foam piece into place in the server.
Be careful not to disturb the surrounding assemblies and cables.
If necessary, fit the power cables in the opening located in the center of Foam Piece 1 (Figure 2-25).
Slide the bottom of the left inner panel into the groove at the top of the Netra 150 server and tilt the panel inward onto the chassis.
With the Phillips #1 screwdriver, tighten the eight Phillips-head captive screws at the side and top of the left inner panel (Figure 2-26).
The screw at the top front portion of the panel does not attach to anything.
Press the left outer panel against the left side of the Netra 150 server and slide the panel forward until it stops.
Tighten the two Phillips-head captive screws at the rear of the Netra 150 server (Figure 2-27).