Skip Navigation Links | |
Exit Print View | |
Oracle Integrated Lights Out Manager (ILOM ) 3.0 Supplement for the Sun Blade X6275 M2 Server Module |
About This Documentation (PDF and HTML)
Overview of the ILOM Supplement
Dual-Node Identification In CMM ILOM
Clearing Server and CMM Faults
Managing Power Usage and Monitoring Power Consumption
How to View Power Management Properties Using the Web Interface
How to View Power Management Properties Using the CLI
Configuring the Server Power Restore Policy
How to Set the Server Power Restore Policy Using the ILOM Web Interface
How to Set the Server Power Restore Policy Using the ILOM CLI
Switching the Default Serial Port Output Between SP and Host Console
How to Switch Default Serial Port Output Using the ILOM Web Interface
How to Switch Default Serial Port Output Using the ILOM CLI
Determining Current Firmware Versions
How to Download Firmware Updates
Using ILOM to Update System BIOS and ILOM Firmware
Alternate Methods for Updating the System BIOS and ILOM Firmware
Resetting the Service Processor After an Update
Clearing CMOS Settings After an Update (Optional)
Using the edit Command and Configuring the Preboot Menu For Remote Access
How to Use the edit Command and to Configure the Preboot Menu for Remote Access
Resetting the Root Password to the Factory Default
How to Reset the Root Password to the Factory Default
Restoring ILOM Access to the Serial Console
How to Use the Preboot Menu to Restore Access to the Serial Console
Recovering the SP Firmware Image
How to Recover the SP Firmware Image
Indicators, Sensors, and Traps
Refer to the Sun Blade X6275 M2 Installation Guide for additional details on how to log into ILOM using a serial connection.
From the server module node ILOM, enter the command:
-> reset /SP
From the CMM ILOM, enter the command:
-> reset /CH/BLx/NODEy/SP
Where:
x is the slot number of the blade.
y is the node number whose SP will be reset.
Temporarily remove power from the server module by removing it partway from its slot and then reseating it. For details, see the Sun Blade X6275 M2 Server Module Service Manual.
Note - If you are unable to access the ILOM, you can reboot the ILOM by using the CMM ILOM or by removing power from the server module.
The ILOM reboots, and messages begin scrolling on the screen.
Press and hold the Locate button on the server module front panel immediately after reinserting the blade until the preboot menu appears.
Type in xyzzy when you see the message:
Booting linux in n seconds...
Note - You cannot interrupt the ILOM boot process by typing xyzzy until you have configured the settings as described in How to Use the edit Command and to Configure the Preboot Menu for Remote Access. One of these settings sets the value of n, which is the amount of time in seconds that the system waits for your input.
The ILOM preboot menu appears as shown here.
Booting linux in 10 seconds... ILOM Pre-boot Menu ------------------ Type "h" and [Enter] for a list of commands, or "?" [Enter] for command-line key bindings. Type "h cmd" for summary of ’cmd’ command. Warning: SP will warm-reset after 300 seconds of idle time. Set ’bootretry’ to -1 to disable the time-out. Preboot>
See Also