| Skip Navigation Links | |
| Exit Print View | |
|
Sun Blade X6275 M2 Server Module Service Manual |
About This Documentation (PDF and HTML)
Server Module and Components Overview
About the Sun Blade 6000 Modular System Chassis
Powering On and Off the Server Module
Preparation Procedures for Service and Operation
Preparing the Server for Service
Preparing the Server for Operation
Component Removal and Installation Procedures
Removing and Installing Flash Modules
Removing and Installing the Energy Storage Modules
Removing and Installing the Service Processor Board
Removing and Installing USB Flash Drives
Removing and Installing a CPU and Heatsink Assembly
How to Replace the Motherboard Assembly
Diagnostic and Maintenance Information and Procedures
Diagnosing Server Module Hardware Faults
Using the DIMM and CPU On-Board Test Circuitry
Multi-Port Cable Connection Overview
How to Attach a Multi-Port Cable
Clearing CMOS NVRAM and Resetting Passwords
How to Clear the NVRAM Using the BIOS Setup Utility
Recovering from Corrupted Service Processor Firmware
How to Recover the SP Firmware Using the Preboot Menu
BIOS Power-On Self-Test (POST) Codes
Server Module Maintenance Procedures and Information
You can reset a password and clear both the CMOS NVRAM and BIOS password by changing the J42_1 (compute node 0) and J42_2 (compute node 1) jumper positions.
Note - The Sun Blade X6275 M2 Server module is a dual-node server. If necessary, use this procedure for both nodes.
This action clears the CMOS and resets the BIOS password.
|