About This Documentation (PDF and HTML)
Server Module and Components Overview
About the Sun Blade 6000 Modular System Chassis
Powering On and Off the Server Module
Preparation Procedures for Service and Operation
Preparing the Server for Service
Preparing the Server for Operation
Component Removal and Installation Procedures
Removing and Installing Flash Modules
Removing and Installing the Energy Storage Modules
Removing and Installing the Service Processor Board
Removing and Installing USB Flash Drives
Removing and Installing a CPU and Heatsink Assembly
How to Replace the Motherboard Assembly
Diagnostic and Maintenance Information and Procedures
Diagnosing Server Module Hardware Faults
Using the DIMM and CPU On-Board Test Circuitry
Multi-Port Cable Connection Overview
How to Attach a Multi-Port Cable
Clearing CMOS NVRAM and Resetting Passwords
How to Clear the NVRAM Using the BIOS Setup Utility
How to Clear the CMOS and Reset the BIOS Password Using Jumpers
Recovering from Corrupted Service Processor Firmware
How to Recover the SP Firmware Using the Preboot Menu
BIOS Power-On Self-Test (POST) Codes
Server Module Maintenance Procedures and Information
The front panel has the following LEDs:
Locate LED helps you find the server. You can activate the Locate LED using ILOM. For more information, see Using the Locate LED to Find the Server Module (Optional).
Ready to Remove LED indicates when it is safe to remove the server module.
The Power OK LED allows you to discern the power state of the server. For more information, see Power Button and Power OK LED.
The Service Action Required LED indicates if the server has a fault.
The following illustration and table show the location and function of the front panel LEDs.
Note - After server module insertion into a powered-on chassis, all front panel LEDs blink three times.
|
See Also: