About This Documentation (PDF and HTML)
Server Module and Components Overview
About the Sun Blade 6000 Modular System Chassis
Powering On and Off the Server Module
Preparation Procedures for Service and Operation
Preparing the Server for Service
Preparing the Server for Operation
Component Removal and Installation Procedures
Removing and Installing Flash Modules
Removing and Installing the Energy Storage Modules
Removing and Installing the Service Processor Board
Removing and Installing USB Flash Drives
Removing and Installing a CPU and Heatsink Assembly
How to Replace the Motherboard Assembly
Diagnostic and Maintenance Information and Procedures
Diagnosing Server Module Hardware Faults
Using the DIMM and CPU On-Board Test Circuitry
Multi-Port Cable Connection Overview
How to Attach a Multi-Port Cable
Clearing CMOS NVRAM and Resetting Passwords
How to Clear the NVRAM Using the BIOS Setup Utility
How to Clear the CMOS and Reset the BIOS Password Using Jumpers
Recovering from Corrupted Service Processor Firmware
How to Recover the SP Firmware Using the Preboot Menu
BIOS Power-On Self-Test (POST) Codes
Server Module Maintenance Procedures and Information
Use the following to diagnose DIMM faults:
The DIMM Fault LEDs are located on the server module motherboard adjacent to each DIMM slot.
The Fault Remind button is located on the motherboard next to the Charge Status LED. Pressing the Fault Remind Button lights up the DIMM Fault LEDs for the slots that contain DIMMs that are in a fault state.
The Charge Status LED indicates the usability of the DIMM test circuit. For more information, see Using the DIMM and CPU On-Board Test Circuitry.
The following illustration and table show the locations and functions of DIMM Fault LED, the Charge Status LED, and the Fault Remind button.
|
See Also: