About This Documentation (PDF and HTML)
Overview of the Sun Blade X6275 M2 Server Module Product Notes
System Software Release Features
Integrated Lights Out Manager (ILOM)
Hardware, Firmware, and BIOS Issues
Hardware, Firmware, and BIOS Current Issues
Management and ILOM Current Issues
Capping Power Values in ILOM Web Interface
Reading Server Power Consumption in the CMM
The Server Will Not Boot if the CMM is Off-Line
Locate LED Programmed to Stay On for 30 Minutes (6793865)
Set Port Sharing Error Message Generated When Using SP ILOM Web Interface (6895495)
Green LED Should Slow Blink (1 Hz) During Firmware Upgrade (6862377)
IPMIflash Over USB Interface Fails Due to Unexpected Response to File-upload Command (6856369)
Missing Warning Message While Doing Backup Configuration Without Passphrase (6859295)
Erroneous Chassis Hot Insertion Event Logged After CMM Reboot (6797938)
CMM ILOM Becomes Unresponsive With Multiple CLI Sessions Open (6780171)
CMM ILOM Interface Becomes Unresponsive After Repeated Use (6798257)
Blade Power On Issues With the start /SYS Command (6784708)
SP Network Connection Lost When Issuing Incorrect ipmiflash -I pci Command (6850823)
Powering On Batches of Blades Might Cause a Node to Fail to Power On (6813202)
Softcap Power Limiting Does Not Work When the Host is Powered on After the SP Reboots (6890841)
PCIe EM Native Hot Plug Does Not Work (6804272)
ILOM Power Budget Status Does Not Function Properly When Disabled and Then Enabled (7009654)
This issue is fixed in system software release 1.3.
When performing a firmware upgrade of ILOM, you are given the choice of preserving the configuration information for the current ILOM version before it is upgraded. This includes information configured by the user (account information, network configurations, management settings, etc.). This information is stored in the SP and will be used if you ever decide to go back to the previous version of ILOM.
For example:
-> load -source tftp://serverfolder/ILOM-version-Sun_Blade_X6275M2.pkg
Are you sure you want to load the specified file (y/n)? y Preserve existing configuration (y/n)? y
Typically, you would opt to preserve existing configurations in case you need to roll back to the previous version of ILOM after an upgrade. However, if you choose to not preserve ILOM configurations during the upgrade and answer no to the prompt to Preserve existing configuration (y/n)?, the configurations might be saved anyway.
This action is harmless and can occur intermittently.
Try performing the upgrade again, answering no to the prompt to Preserve existing configuration (y/n)? during an upgrade.