FCode-Based RAID
Utility Commands
These commands are provided through an FCode-based RAID utility
provided with the on-board controllers. You can enter these commands
at the OpenBoot prompt. For details on preparing to enter these
commands to affect a specific controller, see Prepare to Create a RAID Hardware Volume (FCode-based RAID Utility).
|
|
show-children |
Lists all connected physical drives and
logical volumes. |
show-volumes |
Lists all connected logical volumes in
detail. |
create-raid0-volume |
Creates a RAID 0 volume (minimum two
targets). |
create-raid1-volume |
Creates a RAID 1 volume (exactly two
targets). |
create-raid1e-volume |
Creates a RAID 1e volume for an odd number
of target drives (minimum three).
Note - If you specify an even number of target drives (minimum
four) with this command, those drives will be configured and identified
as RAID 10. For an even number of drives, RAID 1e is the functional
equivalent of RAID 10. |
create-raid10-volume |
Creates a RAID 10 volume for an even
number of target drives (minimum four).
For any other number of target drives, this command fails. |
delete-volume |
Deletes a RAID volume. |
activate-volume |
Reactivates a RAID volume after the motherboard has been replaced. |
|