When Running an Emulex HBA in UEFI BIOS Boot Mode, the "Add Boot Device" Command Causes the System to Hang (18240994)

Document Information

Using This Documentation

Sun Blade X4-2B Product Notes

Important Operating Notes

Do Not Install Windows 2012 R2 / Windows 2012 on Ganymede-E FCoE Target in Legacy Boot Mode (19274563)

Sun Blade X4-2B Server Module Fails When Launching Remote Console (18962552)

Do Not Use Sun Blade 6000 Virtualized Multi-Fabric 10GbE M2 Network Express Module 10G Ports Without FEM (18297744)

Dual 16 Gigabit/Sec Fibre Channel / 10Gbps FCoE Host Adapter, Emulex

BIOS MPS Setting Added (18364710 and 18317148 and 15752501)

Dual 8Gb Fibre Channel and Dual 1 GbE or Sun InfiniBand QDR Host Channel Adapter PCIe EM in Slot 0 Causes SP Fault During Reset

System Reset and qla2xxx Error When Removing and Installing Certain PCIe ExpressModules (17605363 and 17763884)

Warm Reset With Certain PCIe ExpressModules in PCIe EM Slot 0 Might Cause Error (16798624 and 17210462)

Do Not Use Operating System Tools or Utilities to Manage UEFI Boot Variables (15818528)

One DIMM in a Channel Has an Uncorrectable Error, Other DIMMs Might Have Errors (16181966)

Hot-plugging 2 PCIe EMs Can Cause Correctable Error Messages (15752501)

Do Not Reboot the SP and Host Simultaneously (16346073 and 17013976)

Oracle ILOM restore_status Parameter Shows Partial Status (7167938)

Oracle ILOM 3.1 Might Not Support the Clearing of Faults Diagnosed by the Oracle Solaris 10 1/13 and Solaris 11.1 Operating Systems (7170842)

Oracle Recommendations for Drive Slot Population and Virtual Drive Creation (7124194)

PXE-booting Fails When Using Cisco Switch (7149683)

UEFI Boot List Settings Might Be Lost When Transitioning Between UEFI and Legacy Boot Modes (7080526)

When Running an Emulex HBA in UEFI BIOS Boot Mode, the

Oracle System Assistant Issues

Oracle Solaris Issues

Oracle VM and VMware ESXi Issues

Linux Current Issues

Windows Issues

Document Errata

Getting Server Firmware and Software Updates

When Running an Emulex HBA in UEFI BIOS Boot Mode, the "Add Boot Device" Command Causes the System to Hang (18240994)

When you use the BIOS Setup Utility menu to access UEFI Driver Control > Oracle Sun Storage 16Gb Fibre Channel LP > Add Boot Device, the system hangs. This issue only occurs on Emulex host bus adapters (HBAs) running in UEFI BIOS boot mode. If you are running the Emulex HBAs in Legacy BIOS boot mode, you will not experience this issue.

Affected hardware and software: Sun Storage 10 Gb FCoE Short Range Optics, Emulex (7101687 and 7101688 Sun Storage 16 Gb FC Short Wave Optics, Emulex (7101685 and 7101686) Platform software releases 1.0, 1.0.1, and 1.1

Workaround:

When you use the BIOS Setup Utility menu, enter this command first: UEFI Driver Control > Oracle Sun Storage 16Gb Fibre Channel LP > Scan for Fibre Devices.

Skip Navigation Links
Exit Print View
	Sun Blade X4-2B Product Notes