JavaScript is required to for searching.
Skip Navigation Links
Exit Print View
Sun Ethernet Fabric Operating System

PIMv6 Administration Guide

search filter icon
search icon

Document Information

Using This Documentation

Product Notes

Related Documentation

Acronyms and Abbreviations

CLI Command Modes


Support and Accessibility

SEFOS PIMv6 Overview

Supported Features

Protocol Description

Default Settings

Topology Example

Configuring the Topology Example

Enable IPv6 Support and Assign IPv6 Addresses

Configure PIMv6 in Router A

Configure PIMv6 in Router B

Global Configurations

Enable PIMv6

Configure the Group and Source Thresholds

Configure the SPT Switching Period

Configure the Rendezvous Point Threshold

Configure the RP Switch Period

Configure the regstop Rate Limit

Configure the PMBR Status

Configuring PIMv6 on an Interface

Associate the PIMv6 Component to an Interface

Configure the Query-Interval Value

Configure the DR Priority Value

Configure the Override Interval

Configure the LAN Delay

Configure the LAN Prune Delay

Configure the BSR Candidate

Configure the Message Interval

Configuring the PIMv6 Component

Create a PIMv6 Component

Set the Mode for the PIMv6 Component

Configure the RP-Candidate Hold Time

Configure the RP-Candidate Address

Configure the RP Static Address

Create an RP-Set Table

Create a PIMv6 Neighbor

Create Multicast Routes

Associate the PIMv6 Component to an Interface

The ipv6 pim componentId command adds an interface to the PIMv6 component and enables PIMv6 on the interface. You must associate a PIMv6 component with the interface to turn the interface into a supported PIMv6 module. In addition, you must create a component before you associate that component with an interface, except for the default component 1. See Configuring the PIMv6 Component for instructions on how to create a component.

  1. Enable PIMv6.
    SEFOS# configure terminal
    SEFOS(config)# set ipv6 pim enable
  2. Enter the configuration mode for VLAN 1, and associate the VLAN interface with the PIMv6 component ID (2 in this case).
    SEFOS(config)# interface vlan 1
    SEFOS(config-if)# ipv6 pim componentId 2
    SEFOS(config-if)# end
  3. Review the interface status.
    SEFOS# show ipv6 pim interface detail
        PIM Lan-Prune-Delay : Disabled
        PIM Component Id : 2