To enable trap forwarding, issue the following command: itpconfig enable trapforwarding --ipaddress=ipaddress --port=port --community=community
Note - If the trap forwarding is already enabled, use the itpconfig
modify trapforwarding command instead.
Mandatory options for itpconfig enable trapforwarding are:
| |
–-ipaddress
| Sets the destination IP address for the forwarded trap. This can be
loopback (127.0.0.1) or any other valid IP address. This must correspond to
the configuration of the SNMP listener.
|
–-port
| Sets the destination port for the forwarded trap. There is no default
value, but 162 is a common port value. This must correspond to the configuration
of the SNMP listener.
|
–-community
| Sets the destination SNMP V2c community for the forwarded trap. This
value must correspond to the configuration of the SNMP listener.
|
|
Example:
itpconfig enable trapforwarding --ipaddress=127.0.0.1 --port=1234
--community=test