The lag commands adds, configures, displays, and removes a LAG.
add lag name port port-number remove lag {*|*.*|name} set lag {*|*.*|name} [–descr=text] show lag {*|*.*|name}
where:
*. * are wildcards that enable the command to be applied to all LAGs on the fabric.
name is a LAG name (which consists of slot and LAG ID separated by a dot) that enables the command to be applied to a specific LAG.
port-number is the port that will be added.
This hardware command has one subcommand. This table describes the subcommand and provides the syntax.
|
|
This example shows how to configure a static LAG and specify the first port that you want in the LAG.
[OFOS] add lag 0.4 port 3,4,7,8 [OFOS] show lag name state mac-addr descr mode access-vlan ports ------------------------------------------------------------------------- 0.4 up 00:13:97:5D:A0:01 access 1 4