Component Serviceability

The following service actions can be performed on a 3.2 TB NVMe SSD.

• Unmount an NVMe Storage Drive

• Remove an NVMe Storage Drive From the Server

• Verify Removal of an NVMe Storage Drive

• Install an NVMe Storage Drive in the Server

• Power On an NVMe Storage Drive and Attach a Device Driver

Components are either hot serviceable or cold serviceable. Hot service capability allows you to safely remove this component while the server is running after a device orderly shutdown. The Oracle Flash Accelerator F320 PCIe Card supports PCIe presence detect and link-up detect. Cold service capability requires a powered off state, so you need to remove power from the server.

Components are designated either CRU (customer-replaceable unit) or FRU (field-replaceable unit). CRU service capability allows trained technicians and authorized field service personnel to service this component. FRU service capability allows only authorized service personnel to service this component.

Refer to the server documentation for additional service information.

The following table lists the serviceability of NVMe components and directs you to replacement instructions.

Component Serviceability Replacement Instructions Oracle 3.2 TB NVMe SSD (and fillers) Hot CRU Installing the NVMe Storage Drive Replace An Existing NVMe Storage Drive (CRU) For instructions on safe installation and removal of SSDs, refer to the servers service manual. Oracle PCIe NVMe Switch Card Cold FRU For instructions on safe installation and removal of cards, refer to the servers service manual. NVMe cables Cold FRU For instructions on safe installation and removal of cables and connected drive backplane, refer to the servers service manual.

See Also:

• Product Overview

• Technical Support