Go to main content
Oracle® 3.2 TB NVMe SSD User Guide

Exit Print View

Updated: July 2016
 
 

Electrical Specifications

The Oracle 3.2 TB NVMe SSD receives electrical power from the PCI Express +12 VDC and +3.3 VDC power rails as shown in the following electrical specification table:

Specification
12 V Operating Characteristics
3.3 Vaux Operating Characteristics
Operating voltage range

The components inside the SSD were designed to endure a range of voltage fluctuations, which might be induced by the host system,
12 V (+10%/-20%)

For 12 V operating voltage, the minimum allowable is 10.8 V and the maximum is13.2 V.
3.3 V (+-9%)

For 3.3 Vaux, the minimum allowable voltage is 2.97V and the maximum is 3.63V.
Rise time (Max/Min)
50ms/1ms
50ms/1ms
Fall time (Max/Min)

Fall time needs to be equal or better than minimum in order to guarantee full functionality of enhanced power loss management.
5s/1ms
5s/1ms
Noise level
300 mV pp 10Hz – 100 KHz
50 mV pp 100KHz – 20 MHz
300 mV pp 10Hz – 100 KHz
50 mV pp 100KHz – 20 MHz
Power Consumption

Power consumption was measured in the 12 V power pins (#P13~#P15) of the connector plug in SSD. The active and idle power is defined as the highest averaged power value, which is the maximum RMS average value over 100 ms duration.
12 V Active

The measurement condition for active power is assumed for 100% sequential read or write.

  • Read 16W

  • Write 20W

Idle

The idle state is defined as the state that the host system can issue any commands into SSD at any time.

: 7W
Off: 0W
Max 1 mA (at Read current)
Inrush Current
1.8 A
10 mA (1 ms rising time)

Related Information

Copyright © 2016, Oracle and/or its affiliates. All rights reserved. 
Previous
Next