The program description deals with the following:
The data for a G&D-Winkel EFT device can be updated, i.e. programmed, changed or cleared, with this program. Data which has already been stored can also be displayed for information.
EFT devices are required for payments by magnetic cards.
The interface and link to a processing unit should be defined and the device-specific operating mode of the EFT device set.
The following description deals with all available options for update of this basic data.
As with nearly all other programs the following also applies here:
Field with firmly defined selection options
Select one of the baud rates offered by clicking onto this field and with a second click confirming the selection.
The system offers the following baud rates:
Please note that the baud rate permitted must match up with the setting of the connected EFT terminal.
Field with firmly defined selection options
Select one of the offered debug levels by clicking onto this field and with a second click confirming the selection.
The system offers the following debug levels:
Note:
Only select a value higher than "0" for
the debug level if a communications protocol is required for error analysis.
The details can be found in file "errlog" in directory work of the appropriate system unit.
Field with firmly defined selection options
Select one of the EFT types offered by clicking onto this field and with a second click confirming the selection.
The system offers the following EFT types:
Entry range permitted: numeric
Default = 20000 milliseconds
Entry range permitted: numeric
Default = 600 milliseconds
Entry range permitted: numeric
Default = 10000 milliseconds
Enter a value in milliseconds to define the intervals at which the EFT must respond after a status call up. The error message EFT offline is sent if the response is negative.
Entry range permitted: numeric
Default = 2000 milliseconds
Entry range permitted: alphanumeric max. 6 chars.
Enter the password in this field.
Entry range permitted: numeric 1 - 9
Enter 1 here not 0. A Payment type of category EFT should also be programmed. The EFT type and the payment type must be identical with the usage code entered here.
Entry range permitted: numeric 1 - 999
The code for the local currency should be entered in this field. The default is 978 for Euro.
Switch active: Slip
printer of EFT terminal is used
Switch deactivated: POS printer
used as slip printer
Switch active: The
entered amount should be confirmed on the EFT
Switch deactivated: Recording
without confirmation
Switch active:.
Additional status information is provided in customer display
Switch deactivated: No status
information shown in customer display
Switch active: No
administration functions possible on EFT terminal
Switch deactivated: Administration
functions possible on EFT terminal
Switch active: The
terminal sends the currency code set
Switch deactivated: The terminal
sends no currency code