The program description deals with the following:
The data for connection of a payment terminal, type ST2711 EFT, can be updated, i.e. programmed, changed or cleared, with this program. Data which has already been stored can also be displayed for information.
The interface and link to a processing unit should be defined and the device-specific operating mode of the EFT terminal set.
Payment terminal devices are required to handle payments by magnetic cards. Other parametering is necessary, e.g. a Payment type with link of the correct Credit card etc., to operate this device.
The following description deals with all available options for update of this basic data.
As with nearly all other programs the following also applies here:
Field with firmly defined selection options
Select one of the offered debug levels by clicking on this field and with a second click confirming the selection.
The system offers the following debug levels:
Note:
Only select a value higher than "0" for
the debug level if a protocol for the communication of the payment terminal is
required for error analysis. The details are shown in file "errlog"
in directory work
of the appropriate system unit.
Entry range permitted: numeric
Entry range permitted: numeric
Entry range permitted: numeric
Entry range permitted: alphanumeric max. 7 pos.
Entry range permitted: numeric
Default = 1500 milliseconds
Entry range permitted: numeric
Default = 2000 milliseconds
Entry range permitted: numeric
Default = 60000 milliseconds
Entry range permitted: numeric
Default = 8000 milliseconds
Entry range permitted: numeric
Default = 1
Enter the ID no. of the terminal. The value entered must correspond to the one in the appropriate payment type, i.e. the terminal whose no. is entered in the program Payment type will be selected.