4.428 rept-stat-seas

Use this command to generate a summary report of the status of the SEAS subsystem on the EAGLE. This command reports the status of the CCS MR connections if the SEAS Over IP feature is turned on. See the Maintenance Guide for information about the SEAS alarms.

Parameters

This command has no parameters.

Example

rept-stat-seas

Dependencies

No other rept-stat-xxx command can be in progress when this command is entered.

The SEASCFG Table must be accessible.

Notes

None

Output

This example shows output when the SEAS Over IP feature is turned on.

rept-stat-seas

    tekelecstp 07-01-11 16:47:51 EST  EAGLE 37.5.0

        SEAS SYSTEM                           PST         SST          AST
    ----------------------------------------------------------------------------
                                             IS-NR       Avail        -----
        ALARM STATUS = No Alarms
        TERM         IPADDR           PORT    PST         SST          AST
    ----------------------------------------------------------------------------
        18           120.30.10.11     15      IS-NR       Active       -----
        ALARM STATUS = No Alarms
        40           128.30.15.12     16      IS-NR       Active       -----
        ALARM STATUS = No Alarms

Legend

• PST—Primary state of the subsystem. Possible values are described in Possible Values for PST/SST/AST.
• SST—Secondary state of the subsystem. Possible values are described in Possible Values for PST/SST/AST.
• AST—Associated state of the subsystem. Possible values are described in Possible Values for PST/SST/AST.
• SEAS SYSTEM—Overall SEAS component