About This Documentation (PDF and HTML)
SAS Device Access to the Chassis SAS-2 Domain
Host Access to Storage Module Resources Using the Sun Blade Zone Manager
How to Assign Storage to Hosts Using the CMM ILOM Web Interface
How to Assign Storage to Hosts Using the CMM ILOM CLI
Overview of Storage Module Management
Management Options Using the CMM ILOM
Management Options Using the Sun Storage 6Gb SAS REM RAID HBA (SGX-SAS6-R-REM-Z)
Management Options Using the Sun Storage 6Gb SAS REM HBA (SGX-SAS6-REM-Z)
Performing Maintenance and Hot Plug Actions
Preparing for Hot Plug Actions
Recovering Zoning Configurations
Upgrading Storage Module Firmware
Importing Existing Virtual Drives to a Replacement REM
Replacing a REM on a SPARC System
Replacing a REM on an x86 System
Storage Module Sensors and Indicators
Displaying Sensor and Indicator Information Using the CMM ILOM Web Interface
Displaying Sensor and Indicator Information Using the CMM ILOM CLI
Viewing the CMM ILOM Event Log
SAS Path Disappears and ILOM /CH/NEMx/fault_state is "Faulted"
NEM STATE (/CH/NEMx/STATE) is Not "Running"
If you lose access to the storage module from the host and the NEM fault LED comes on, check the following:
An over-temperature might have occurred. Check to ensure the chassis has proper cooling:
That data center air conditioning is on and chassis fans are functioning.
That all PCIe EM slots contain either a filler or a PCIe EM card.
That all chassis slots have either a blade or filler panel installed.
An internal component, such as the SAS expander, might be in an error state. Refer to SAS Path Disappears and ILOM /CH/NEMx/fault_state is "Faulted".