Flash Module Architecture Overview
Energy Storage Module Overview
Perform ESD Prevention Measures
(Optional) Install Full-Height Bracket
Install the Card Into a System
FMod Alignment for Optimal Performance
(Optional) Using the SAS/SATA Controller as a Boot Device
SAS/SATA Controller as a Boot Device
Configure the SAS/SATA Controller as a Boot Device (SPARC Systems)
Configure the SAS/SATA Controller as a Boot Device (x86 Systems)
Replacing FMod Retention Clips
Monitoring ESM Lifespan Options
Sun Flash Accelerator F20 ESM Monitoring Utility
Oracle ILOM ESM Monitoring for SPARC T-Series Servers
Oracle ILOM ESM Monitoring for x86 X Series Servers
XSCF ESM Monitoring for SPARC M Series Servers
Remove the ESM (Alternate Configuration)
Install the ESM (Alternate Configuration)
Update the FMod Firmware (Oracle Solaris OS)
Update the FMod Firmware (Windows and Linux OS)
Updating the SAS/SATA Controller Firmware
Update the SAS/SATA Controller Firmware (Oracle Solaris OS)
Update the SAS/SATA Controller Firmware (Linux OS)
Before You Begin
Before you begin, perform the following tasks:
Remove the card from the system and place it on an antistatic mat. For instructions, see the service manual and the product notes for your system.
Caution - The card can be hot when removed. Wait 20 seconds after you remove the card before you touch card components. |
See Remove an FMod.
Note - FMod0 must be removed to access the ESM cable.
Carefully slide the ESM off the card without disturbing FMod3.