How to Prepare for Operation

1. Ensure that all new components are installed as described in the component replacement instructions (see Component Replacement Procedures and Topic).
2. Ensure that all existing components are properly seated and connected.
3. Ensure that all internal cabling is connected and secured within the server and that the cabling is not obstructing the air flow.
4. Inspect the interior of the server and remove any tools and loose or foreign debris.
5. Use a vacuum, compressed air, or an antistatic brush to clean the interior of the server so component surfaces and server air vents are free of dust.

   ---

   Caution - Potential for component damage. Do not use liquid or aerosol spray cleaners to clean the server. Liquid has the potential for causing shorts in electrical systems.

   ---

6. Install the system’s cover. See How to Install the Server Cover.
7. Install the server in the rack. See How to Install the Server Into the Rack.
8. Connect all external cables to the system.
9. To apply AC power, connect the AC power cords to the server.

   When the AC power is applied, the server enters standby mode.

10. Power on the server. See How to Power On the Server.

See Also

Sun Fire X2270 M2 Server Service Procedures and Information