Skip Navigation Links | |
Exit Print View | |
![]() |
Oracle Integrated Lights Out Manager (ILOM) 3.0 Supplement for the Sun Fire X2270 M2 Server |
About This Documentation (PDF and HTML)
Overview of the ILOM Supplement
Supported ILOM 3.0 Feature Set
Sun Fire X2270 M2 Server Platform-Specific Features
Communicating With the ILOM and the System Console
Server Back Panel LEDs and Ports
About ILOM SP IP Addresses and the ILOM Interfaces
Connecting to the System Console
ILOM Platform Features for the Sun Fire X2270 M2 Server
Switching Serial Port Output Between SP and Host Console
How to Configure Sideband Management Using the Web Interface
How to Configure Sideband Management Using the CLI
Running IPMITool from the Host
Updating ILOM Firmware Using the IPMIflash Utility
How to View the Sensors From the System BIOS
BIOS System Event Log Sensor Error List
Using ILOM to Monitor the Host
Determining Current Firmware Versions
Preparing for a Firmware Update
When sideband management is enabled in ILOM, the following conditions might occur:
In-chip connectivity between the SP and the host operating system might not be supported by the on-board host GigabitEthernet controller. If this condition occurs, use a different port or route to transmit traffic between the source and destination targets instead of using L2 bridging.
Server host power cycles might cause a brief interruption of network connectivity for server Gigabit Ethernet ports (NET 0, 1) that are configured for sideband management. You should configure the adjacent switch or bridge ports as host ports. Note that if the ports are configured as switch ports and participate in the Spanning Tree Protocol (STP), you might experience longer outages due to spanning tree recalculation.