Remove SLB Server Members

Document Information

Using This Documentation

Product Notes

Related Documentation

Acronyms and Abbreviations

CLI Command Modes

Feedback

Support and Accessibility

SLB Overview

Configuring the SLB Topology Example

SLB Description

SLB Topology Example

SLB Configuration Guidelines and Prerequisites

Default Settings

Configuring the SLB-L2 Topology Example

SLB-L2 Description

Sample SLB-L2 Topology Example

SLB-L2 Configuration Guidelines and Prerequisites

Default Settings

Conditions for a Member Participating in Load Distribution

Configuring SLB Entries

Create SLB Server Members

Remove SLB Server Members

Set the Traffic Distribution Policy

Restore the Default Traffic Distribution Policy

Create Multiple LBGs

Server Health-Check Function

Configuring SLB-L2 Entries

Create SLB-L2 Server Members

Remove SLB-L2 Port Members

View the Traffic Distribution Policy

Restore the Default Traffic Distribution Policy

Set the Failover Method

Restore the Default Failover Method

Create Multiple SLB-L2 Groups

Creating Example SLB Configurations

Creating a Basic SLB Configuration

Basic SLB Configuration

Basic SLB Configuration Steps

Set Up the Switch

Set Up the Client

Set Up the Server

Enable the Switch Ports

Save the Current Configuration

Creating a Separate VLAN SLB Configuration

Separate VLAN SLB Configuration

Configuration With Separate VLANs Steps

Set Up the Switch

Set Up the Client

Set Up the Server

Enable the Switch Ports

Save the Current Configuration

Creating a Multiple SLB Group Configuration

Multiple-SLB-Group Configuration

Configuration With Multiple SLB Groups Steps

Set Up Switch A

Set Up Switch B

Set Up the Client

Set Up the Servers in SLB Group 1

Set Up the Servers in SLB Group 2

Enable the Switch Ports

Save the Current Configuration

Creating a Failover Example

Failover Example

Trigger a Failover

Restart the Server Following Failure

Creating SLB-L2 Configuration Examples

Bump-In-The-Wire Configuration

Creating a Single-Switch Configuration

Basic Single-Switch Configuration

Create a Single-Switch Configuration

Creating a Dual-Switch Configuration

Dual-Switch Configuration

Create a Dual-Switch Configuration

Creating an SLB-L2 Failover Example

SLB-L2 Failover Example

Trigger a Failover

Restart the Interface Following Failure

This example shows removing one server member from an LBG. You use the same process to remove an active or standby server member.

Remove the server entry.

SEFOS# configure terminal
SEFOS(config)# no slb standby 10.10.10.0 255.255.255.0 192.0.0.2
SEFOS(config)# end

Show current LBGs and members.

The following example shows the removal of one of the active SLB server members.

SEFOS# show slb
 
SLB Group ID: 1 Virtual IP: 10.10.10.0/24
Server Members:
IP Address       Vlan  MacAddress        Port  State    Comments
================ ====  ================= ==== ========= ==================
192.0.0.1         1    00:14:4f:3e:e0:10    3   ACTIVE
192.0.0.3         1    00:14:4f:3e:e0:19   12   STANDBY   (up)

Skip Navigation Links
Exit Print View
	Sun Ethernet Fabric Operating System SLB Administration Guide

SLB Administration Guide

Remove SLB Server Members