About This Documentation (PDF and HTML)
Overview of the Sun Blade X6275 M2 Server Module
Server Module Front Panel and Indicators
Installing and Powering On the Server Module
About Your Server Module Shipment
Finding the Serial Number and Accessing Warranty Support Information
How to Install Your Server Module
How to Apply Full Power to a Server Module Node
How to Power Off a Server Module Node
Troubleshooting Server Power States
How to Display the ILOM IP Address Using the Web Interface
How to Display the ILOM IP Address Using the CLI
How to Log In to the ILOM Web Interface Using an Ethernet Connection
How to Log In to the ILOM CLI Using an Ethernet Connection
How to Log Into ILOM Using a Serial Connection
Configuring an ILOM IP Address
How to Configure a DHCP IP Address
Accessing the Host Console Through ILOM
How to Connect to the Host's Serial Console Using the ILOM Command-Line Interface
How to Connect to the Host Console Using the ILOM Web Interface
If you plan to assign a static IP address to a server node's ILOM service processor, perform the following procedure.
For example:
$ ssh username@CMMIPaddress
where username is a user account with administrator privileges and the CMMIPaddress is the IP address of the CMM ILOM.
Tip - The default ILOM administrator account user name is root and the password is changeme. If this default administrator account has been changed, contact your system administrator for an ILOM user account with administrator privileges.
Substitute the static IP address and the network configuration information to be changed. To see the current configurations, use the show command in /CH/BL4/NODE0/SP/network.
For example, you might enter the following commands:
-> cd /CH/BL4/NODE0/SP/network -> set pendingipaddress=129.144.82.26 -> set pendingipnetmask=255.255.255.0 -> set pendingipgateway=129.144.82.254 -> set pendingipdiscovery=static -> set commitpending=true
For example, if you have already configured NODE0, you would then enter the commands to configure NODE1.
-> exit
See Also