Sun Storage 16 Gb Fibre Channel ExpressModule Universal Host Bus Adapter, QLogic Installation Guide For HBA Model 7101682

To Determine and Change the Operating Protocol Mode Using the FCode Utility

This procedure describes how to determine and change the operating protocol mode of the universal HBA using the FCode utility on Oracle SPARC systems.

1. Type the show-disks command at the ok prompt to list the FC/FCoE device path.

   {0} ok show-disks
   a) /pci@400/pci@2/pci@0/pci@f/pci@0/usb@0,2/hub@2/hub@3/storage@2/disk
   b) /pci@400/pci@2/pci@0/pci@4/SUNW,qlc@0,1/fp@0,0/disk
   c) /pci@400/pci@1/pci@0/pci@4/SUNW,qlc@0/fp@0,0/disk
   d) /pci@400/pci@1/pci@0/pci@0/pci@0/usb@0,2/hub@3/storage@2/disk
   e) /iscsi-hba/disk
   q) NO SELECTION
   

2. Type the select command at the ok prompt to select the first port of the universal HBA.

   {0} ok select /pci@400/pci@1/pci@0/pci@4/SUNW,qlc@0
   QLogic QLE8362 FC Host Adapter FCode(SPARC): 4.02b1 2012-06-25 08:51
   ISP Firmware version 6.00.12
   

3. Type the set-personality command at the ok prompt to change the operating protocol mode of the universal HBA.

   The following example shows the mode being changed (in this case, from FC to CNA):

   {0} ok set-personality
   Current Personality : FC
   Do you want to change it? (y/n) y
   Choose Personality :
   0 - FC
   1 - CNA
   enter: 1
   .
   {0} ok reset-all