Part IV

Installing and Configuring an LDAP Server

If you choose to use LDAP, WebCenter Sites must have access to a supported LDAP server specifically configured for WebCenter Sites. This part describes how to install and configure a supported LDAP server for integration with WebCenter Sites.


You must set up a supported LDAP server before you run the WebCenter Sites-LDAP integrator.

If you are integrating with LDAP, but no content management sites exist in WebCenter Sites, then upon completion of the LDAP integration procedure, refer to instructions in Section 20.4, "Post-Integration Steps: When CM Sites Have Not Been Created."

Part IV contains the following chapters: