Reinstall the Server Chassis Into the Rack
If you removed the server chassis from the rack, perform these steps to
Caution - Deploy any rack anti-tilt mechanisms before installing the server into the rack.
Caution - The server weighs approximately 18.0 kg (40.0 lbs). Two people are required to
carry the chassis and install it into the rack.
- Push the slide-rails into the slide-rail assemblies in the rack as far as possible.
- Raise the server so that the rear ends of the mounting brackets are
aligned with the slide-rail assemblies that are mounted in the rack.
- Insert the mounting brackets into the slide-rails, and then push the server into
the rack until the mounting brackets encounter the slide-rail stops, approximately 30 cm (12
The server is now in the extended maintenance position.
Figure 68 Returning the Server to the Rack
1 Inserting mounting brackets into slide-rails
2 Slide-rail release tab (green)
3 Slide-rail lock